AM Medium Wave Crystal Radio Antenna RF Amplifier Unassembled Parts Kit-GREEN

Description

This is a DIY Parts Kit-The Device IS NOT Assembled
Once again it is not assembled-All parts are loose in a sealed Plastic Bag
Some pictures show what the Amplifier appears after assembly
Requires ability to read a schematic Diagram and Soldering Experience
AM Medium Wave Active Antenna amplifier for your AM Crystal Radio
Works Reliably and Pulls in AM Radio broadcasts like a magnet
Battery not included
PC Board Size is Compact 94mm x 54mm
Special Features :
NEW Improved Model
Has a convenient Battery Holder Clip mounted to the PC Board
Runs on a 9V battery
Circuit board is designed with easy to connect Terminal blocks and additional solder pads for connection flexibility
Input, Output and Ground Connections are
solderless
using the Terminal Blocks
PC Board has holes in corners for mounting into a project enclosure or installing standoffs
Easily fits into many project enclosures
Latching Pushbutton Switch enabled Power (Use switch to turn the Power off when not in use to conserve Battery Life)
LED Power Indicator tells you when the amplifier has power from the 9V Battery turned on
Broadband type, covers the full AM band
Lightweight and very compact
Terminal Blocks mounted on the PC Board for direct connection to Antenna and Radio
Input and Output terminals are clearly marked on printed Circuit Board
Ground terminals are clearly marked
on printed Circuit Board
Easy to set up and operate
DO NOT OPERATE ON A METAL SURFACE AS THE PC BOARD WILL SHORT OUT
This Active Antenna Amplifier uses a FET Transistor to boost the signal with
almost no load felt by the antenna.
It's comparable to adding 40 to 60 foot of Antenna Wire to your shorter existing Crystal Radio Antenna
During my tests, stations that were weak and scratchy came in with amazing results (even when using a 40 -foot wire antenna and an antenna tuner). Depending on the circuit of your radio, the added gain may be as much as 100 %.
This is a compact, battery operated antenna amplifier designed for AM Crystal Radios radios. By connecting this small equipment between your radio and antenna system, the gain increases by as much as 100 %. This is a real performance
enhancer
for your Crystal Radio. It is very easy to set up and run, uses a 9 volt battery, This amplifier uses a FET transistor which is able to cover full AM band. You can use this amazing device with any crystal radio which utilizes both antenna and ground connections. By this small amplifier you can listen more stations especially the long distance ones. No extra tuning is needed.
I send the connection diagram and schematic by email with the purchase of this amplifier.
Performance is very good and stations can be picked up even with a short antenna.